top of page
*REBUILD KITS AVAILABLE
4" INCH BACKWASH VALVES
description
Everfilt® 4-Inch Backwash Valves are a 3-port, two-way valve, combining both filtration and backwash modes in a single unit. Designed to be fully open in either position, giving full unrestricted flow at all times. Carefully designed and tested since 1978 and has a proven track record for reliability and function. Constructed from ductile iron and finished with a fuze coated exterior and 3M-134 NSF-Approved interior epoxy and fuze coat exterior. The service port and flush port are used instead of standard maintenance, where severe conditions require interim maintenance. Service Port: Remove the rubber cover and inspect the interior of the actuator housing and backwash shaft. Lubricate backwash with light weight oil or an aerosol spray (WD-40). Hydraulically operate the actuator to ensure proper operation. Replace rubber cover to protect actuator interior. Flush Port: To flush the diaphragm, remove 1/4" drain plug and manually operate the actuator control valve to initiate a backwash. Source water will enter the actuator and flush the accumulated debris out of the flush port. Repeat this cycle as required. Replace 1/4" drain plug and return the actuator control valve to normal mode for proper operation.
features
total length: 15.5"
total height: 8"
psi: 125 [standard] 250 [modified]
gpm: 175 [cv]
operation: manual, automatic, pneumatic, hydraulic
construction: ductile iron
COATINGS: 3m-134 epoxy coating / fuze coat
Everfilt® Backwash Valves
Everfilt® Backwash Valves
Everfilt® Backwash Valves
1/2
Select models are subject to change due to customizations or product changes. Contact a representative for more info on a series of interest.
bottom of page